Factory reset of ASSA motor lock, with LED beside group switch
See page 4.
Initiation
Door monitor switch in motor lock and fail safe/safe secure electric strike
Door monitor input DIP 7 – Electric strike Explanation/result.
Closed OFF Sensor in motor lock active Safe secure function on electric
strike (Normal mode).
ON Sensor in motor lock active Fail safe function on electric strike.
Open ON Sensor in motor lock inactive Fail safe function on electric strike.
OFF Sensor in motor lock inactive Safe secure function on electric
strike.
Button input behaviour at initiation
Button input:
open at initiation
The input will be level triggered, i.e. DAC will set the door unlocked as long as the
input is closed, which is normal mode.
Button input: closed
at initiation
The input will be flank triggered, i.e. DAC will lock the door according to set time
if the input remains closed while running.
Information ASSA motor lock
When there is an LED mounted beside the switch on the case (LED is only visible with the lock in the hand).
This locks you can do a factory reset on the lock. The LED function is to facilitate the installation and trou-
bleshooting.
Steady light Factory mode, Not initiated.
LED off Initiated
Flashing LED (~2Hz) "Wrong DAC" lock already initiated against another DAC.
Flashing LED (~10Hz) Timeout. Initiate DAC again or reset the lock as shown below.
12
To Next Page
Loading...
Need help?
General
