5
Signature
®
Series
SARGENT‘s Signature cylinder contains two (2) blocking bars.
The bar is placed so that the witness mark side of the bar is either toward the keyway broaching or away from the
keyway broaching.
GUIDE TO OFFSET BAR ORIENTATION
Blocking Bar Configuration
The position of the bars is determined by the last (seventh) digit of the Signature code pattern
stamped on the keys to be used.
There are currently two sets of configurations (positions) assigned by the factory for a
Signature code pattern. They are identified by the digit 4 or 2 as the seventh or last
character of the Signature code pattern.
See the illustration below for the proper orientation of the bars.
If necessary, reinsert the four blocking bar springs (two for each blocking bar or one for each
end of a blocking bar) and then the bars (in the correct configuration) as illustrated below.
AA12
PATENT
PENDING
1A1A124
2
4
7
A7438F • 1-800-727-5477 • www.sargentlock.com
9/01/16 Copyright © 2007, 2011, 2014, 2016, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
To Next Page
Loading...
