All Schedule Types
Enabled/Disabled
Schedule(s) has been enable/disabled for
specified user ID
Master code was changed at keypad
Master code was changed over RF
User added. Alarm level = user slot
number
Where Alarm level represents user slot
number
Alarm generated in response to add user
RF cmd.
This alarm is not generated when
attempting to add duplicate pin at the
keypad. The lock simply denies it and
plays the “Denied”. Trying to duplicate
the master code will result in a 0x71 0x00
alarm report.
Disabled user
entered at keypad
A disabled user pin code was entered at
the keypad
Valid user but
outside of schedule
A valid user can be both a normal user
and a Non-Access user. If a non-access
user is out of schedule this alarm will be
sent instead of the non-access alarm.
keypad attempts exceed code entry limit
front escutcheon removed from main
After a low battery alert was observed, the
lock was powered down and powered back
up with full battery.
To Next Page
Loading...
Need help?
General
