Made the following updates:
• Added Command Class Clock section.
• Added Clock Report to the Association Group Info commands list.
• Marked Time as a secure command class.
• Added the following note to Time, Time Parameters, and Clock
command classes: “If the controller does not support either the
Time CC, Time Parameters CC, or Clock CC, then scheduled users
will not have access.”
• Added a brief description of the time syncing mechanism to the
Command Class Time section.
• Changed Master Code slot from 0xFB to 0x00 in Notifications
Table.
Made the following updates:
• Marked the Version command class as secure.
• Added Basic command class.
• Added information about non-access user codes to the User Code
command class section.
Updated the Product ID description in the “Command Class
Manufacturer Specific” section.
Made the following updates:
• Added interconnected locks: YRC216, YRC226, YRC256
• Added configuration parameter 28 (expiration time) to the
Configurable Parameters table.
Made the following updates:
• Provided Version Report example
• Add mapping of Basic CC to Door Lock CC
• Updated CC descriptions that required security
• Updating Configuration Parameter Table
• Fixed the Max Nodes for Association
• Add information on how our Lock uses the Indicator feature
• Add information how to trigger unsolicited AGI Lifeline reports
• Add description of OTA internal step
• Updated User Code User ID Status Values from CC v1 vs v2
• Removed support for Clock CC
• Added NF-YRD612, NF-YRD622, NF-YRC612, NF-YRC622 and
YRC652
• Added SmartStart feature statement
• Added YRD622, YRD642, YRC622 and YRC642
• Expectations from User Code Set/Get vs Extended User Code
Set/Get Commands
• Added YRD410/420/430/450
• Added BLE Alarms from BLE locks
• Added description of what other features are affected when
Passage Mode and Escape Return Mode features are enabled.
To Next Page
Loading...
Need help?
General
