10
C
AUTION:Make sure that both of the portafilter wings are
securely aligned and that the portafilter has created a tight seal
with the group head gasket. If a tight seal is not created, a
potentially dangerous situation exists as hot water under pressure
could escape from the group head causing burn injuries. NEVER
remove a portafilter from the group head while it is under pressure
and brewing. Push the Brew/Stop button to stop brewing or wait
until the brew cycle stops.
1. Press and hold the Start/Stop button for 5 seconds. All the lights
start flashing indicating that you are in the program mode.
2. Load the Portafilter with coffee and lock it to the machine. Press
any key that you like to program. The machine starts to
dispense. Once you have enough extraction press, “Start/Stop”
button. The machine will stop and the specific button now has
been programmed.
3. Repeat step 2 for all other buttons that you wish to program.
4. Press “Start/Stop” button to Exit the program Mode.
5. If you wish to copy the stored program from one touchpad to
the other Touchpad.
A. Press and hold the “Brew/Stop” button on the touchpad you
like to program for 10 seconds. All the lights will start to
finish.
B. Remove your hand and press the button “Brew/Stop” again
momentarily. All the lights go out and the program is copied.
While the machine is extracting espresso, pump pressure gauge
will read approximately 135 PSI. On the front panel there are two
lights: green and amber. The green light indicates that the machine
is on while the amber light indicates when the heating element is
operating. The amber light will go on intermittently while the
machine is on regardless of whether it is in use or not.
To Next Page
Loading...
