8
Brew
/Stop Button
The Brew/Stop button is a manual override for all selections. If you
should push the wrong selection, press the Brew/Stop button to
cancel that selection. If you need to extract an amount not
programmed, put the cup under the portafilter and push the
Brew/Stop button for extraction to begin. Once the desired level is
reached, push the Brew/Stop again to complete the extraction.
The Brew/Stop button can also be programmed as a fifth selection.
If you have programmed this button and now wish to return to
manual override, you must do the following:
1. Press and release the Brew/Stop button.
2. Quickly press and hold Brew/Stop button until the lights on
the keypad are on. (THE TIME DELAY BETWEEN STEPS 1
AND 2 MUST BE EXTREMELY SHORT.)
3. After a 10 second pause, press and hold the Brew/Stop
button until the lights on the keypad are off.
4. Now the Brew/Stop button is returned to the factory set
manual override.
To Next Page
Loading...
