EasyManua.ls Logo

Astra Pro - Semi-Automatic Espresso Machine

Default Icon
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
H. Semi-Automatic Espresso Machine
The following applies to ALL ASTRA Semi-Automatic machines and
steamers:
Open any steam valve and leave it open by turning the knob
counter-clockwise. Turn the machine on using the On/Off switch on
the front panel. The green and amber lights will come on. Once the
steam begins to disperse from the steam wand, close the valve.
When the arrow on the right side of the gauge is in the green, the
machine is ready to be used.
Take the single portafilter and put it in the yoke of the grinder. Pull
the lever once for a single dose and ensure the coffee is level. It is
NOT necessary to tamp the portafilter because ASTRA espresso
machines come with self-tamping group heads. To put the
portafilter on the group head, hold the handle level at 7 o’clock and
lift it up into the group head. Make sure the portafilter wings fit into
the slots and turn the handle to the right to create a tight seal.
C
AUTION:Make sure that both of the portafilter wings are
securely aligned and that the portafilter has created a tight seal
with the group head gasket. If a tight seal is not created, a
potentially dangerous situation exists as hot water under high
pressure could escape from the group head causing burn injuries.
NEVER remove a portafilter from the group head while it is under
pressure and brewing. Push the Brew/Stop button to stop brewing
or wait until the brew cycle stops.
Place an espresso cup under the portafilter. Push the right On/Off
switch to the “On” position. Espresso will begin to be extracted
and once the cup is filled to the desired level, press the same
switch to the “Off” position Single doses extract between 1.5 to 2.0
ounces.

Related product manuals