Astra Pro - Operating the Steam Wand

12
• Adjust the temperature between 2-40 degrees Fahrenheit using
the up or down arrows
• Once you have selected the desired temperature, press the
“Set” button
• The display will read “St.2”
• Press “Set” button again
• Display will show the selected temperature from step 1
• Press “Set” button to record the change
4. Setting the Upper Li
mit Parameters
• Press and hold the “Set” button
• Display will read “St.H” (setting the highest temperature)
• Press “Set” button again
• Adjust the temperature between 0-950 degrees Fahrenheit
using the up or down arrows (suggested temp. 250 degrees
Fahrenheit)
• Once you have selected the desired temperature, press the
“Set” button to record the change.
5. Setting the Lower Limit Parameters
• Press and hold the “Set” button
• Display will read “St.L” (setting the lowest temperature)
• Press “Set”
• Adjust the temperature between 0-150 degrees Fahrenheit
using the up or down arrows (suggested temp. is 100 degrees
Fahrenheit).
• Once you have selected the desired temperature, press the
“Set” button.
• The display will show the room temperature and programming
is finished.