6-2
Chapter 6: ATI Hybrid CrossFireX technology support
6.1.3 Installing AMD Chipset Driver
To install the driver that supports Hybrid CrossFireX technology:
1. Insert the Support DVD that comes with your motherboard into the optical
drive. The DVD automatically displays the Drivers menu if Autorun is enabled
in your computer.
If Autorun is NOT enabled in your computer, browse the contents of the support
DVD to locate the file ASSETUP.EXE from the BIN folder. Double-click the
ASSETUP.EXE to run the DVD.
2. From the Drivers menu, click AMD Chipset Driver to install it. Follow the
onscreen instructions to finish the installation.
3. Restart your computer after the installation is completed.
4. When the system restarts, wait for a few seconds for the driver to load
automatically.
6.1.4 Using the ATI CATALYST
®
Control Center
Using an add-on graphics card
1. Install a graphics card onto your motherboard. Refer to the User Guide that
comes with your graphics card for details.
2. Right-click on the Windows
®
desktop, then click ATI CATALYST(R) Control
Center from the shortcut menu. The ATI CATALYST Control Center screen
appears.
3. Click Graphics Settings > CrossFire™, then select the Enable
CrossFire™ check box. When a
confirmation message pops up,
click Yes. The screen blacks out
for about one minute.
4. Click OK. The add-on graphics
card is set to be the main monitor.
To Next Page
Loading...
Need help?
General
