ASUS M4A89GTD PRO Series 4-19
Chapter 4
4.6 Creating a RAID driver disk
®
XP operating system
on a hard disk drive that is included in a RAID set. For Windows
®
Vista or later operating
• The motherboard does not provide a oppy drive connector. You have to use a
• Windows
®
®
XP
limitation. To work around this OS limitation, refer to section 4.6.4 Using a USB
oppy disk drive.
4.6.1 Creating a RAID driver disk without entering the OS
To create a RAID driver disk without entering the OS
1. Boot your computer.
2. Press <Del> during POST to enter the BIOS setup utility.
3. Set the optical drive as the primary boot device.
4. Insert the support DVD into the optical drive.
5. Save changes and exit BIOS.
6. When the Make Disk menu appears, press <1> to create a RAID driver disk.
8. Follow the succeeding screen instructions to complete the process.
4.6.2 Creating a RAID driver disk in Windows
®
To create a RAID driver disk in Windows
®
:
1. Start Windows
®
.
3. Place the motherboard support DVD into the optical drive.
4. Go to the Make Disk menu, and then click AMD AHCI/RAID 32/64bit xxxx Driver to
create a RAID driver disk.
6. Follow the succeeding screen instructions to complete the process.
4.6.3 Installing the RAID driver during Windows
®
OS installation
If you use a SATA optical drive to run the OS installation disk, we strongly recommend that
you install the optical dirve to the SATA connectors 5/6 and set them to [Native IDE] mode.
To install the RAID driver for Windows
®
XP
1. During the OS installation, the system prompts you to press the F6 key to install
third-party SCSI or RAID driver.
To Next Page
Loading...
