3-20 Chapter 3: BIOS setup
Chapter 3
3.5.18 CPU Load-Line Calibration [Auto]
Allows you to select the CPU Load-Line mode.
3.5.19 CPU/NB Load-Line Calibration [Auto]
Allows you to select the CPU/NB Load-Line mode.
3.5.20 CPU Spread Spectrum [Auto]
[Disabled] Enhances the CPU overclocking ability.
[Enabled] Sets to [Enabled] for EMI control.
3.5.21 PCIE Spread Spectrum [Auto]
[Disabled] Enhances the PCIE overclocking ability.
[Enabled] Sets to [Enabled] for EMI control.
3.5.13 HT Voltage [Auto]
Allows you to set the HyperTransport voltage. The values range from 0.80000V to 1.40000V
with a 0.00625V interval.
3.5.14 NB Voltage [Auto]
Allows you to set the Northbridge voltage. The values range from 0.80000V to 2.00000V with
a 0.00625V interval.
3.5.15 NB 1.8V Voltage [Auto]
Allows you to set the Northbridge 1.8V voltage. The values range from 1.80V to 2.10V with a
0.05V interval.
3.5.16 SB Voltage [Auto]
Allows you to set the Southbridge voltage. The values range from 1.10V to 1.40V with a
0.05V interval.
3.5.17 SidePort Memory Voltage [Auto]
Allows you to set the SidePort memory voltage. The values range from 1.50V to 1.80V with a
0.10V interval.
• Setting the above voltages to a high level may damage the CPU, memory module,
and chipset permanently. Proceed with caution.
• The system may require a better cooling system to work stably under high voltage
settings.
To Next Page
Loading...
