3-30 Chapter 3: BIOS setup
Chapter 3
EuP Ready [Disabled]
[Disabled] Disables the Energy Using Products (EuP) Ready function.
[Enabled] Allows BIOS to switch off some power at S5 state to get system ready for
the EuP requirement. When set to [Enabled], power for WOL, WO_USB,
audio and onboard LEDs will be switched off at S5 state.
Restore On AC Power Loss [Disabled]
[Power On] The system goes into on state after an AC power loss.
[Disabled] The system goes into off state after an AC power loss.
[Last State] The system goes into either off or on state, whatever the system state was
before the AC power loss.
Power On By PCI/PCIE Device [Disabled]
[Disabled] Disables the PME to wake up from S5 by PCI/PCIE devices.
[Enabled] Allows you to turn on the system through a PCI/PCIE LAN or modem card.
This feature requires an ATX power supply that provides at least 1A on the
+5VSB lead.
Power On By PS/2 Devoces [Disabled]
[Disabled] Disables the Power On by a PS/2 devices.
[Enabled] Enables the Power On by a PS/2 devices. This feature requires an ATX
power supply that provides at least 1A on the +5VSB lead.
Power On By Ring [Disabled]
[Disabled] Disables to power up the computer when the external modem receives a
call while the computer is in Soft-off mode.
[Enabled] The computer could be powered up when the external modem receives a
call while the computer is in Soft-off mode.
The computer cannot receive or transmit data until the computer and applications are fully
system power on.
Power On By RTC Alarm [Disabled]
[Disabled] Disables RTC to generate a wake event.
[Enabled] When set to [Enabled], the items RTC Alarm Date (Days) and System
Time
3.7.5 APM Conguration
APM Conguration
EuP Ready [Disabled]
Restore on AC Power Loss [Disabled]
Power On By PCI/PCIE Device [Disabled]
Power On By PS/2 Devices [Disabled] PS/2 Devices [Disabled]
Power On By Ring [Disabled]
Power On By RTC Alarm [Disabled]
BIOS SETUP UTILITY
Power
To Next Page
Loading...
