2. USB connectors (10-1 pin USB78, USB1112; A-Type USB9, USB10)USB connectors (10-1 pin USB78, USB1112; A-Type USB9, USB10)
These connectors are for USB 2.0 ports. Connect the USB module cables
to connectors USB78 and 1112, then install the modules to a slot opening at
the back of the system chassis. These USB connectors comply with USB 2.0
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
then install the Q-Connector (USB) to the USB connector onboard.
The USB cable is purchased separately.
3. Serial port connector (10-1 pin COM1)
This connector is for a serial (COM) port. Connect the serial port module
cable to this connector, then install the module to a slot opening at the back
of the system chassis.
The COM module is purchased separately.
To Next Page
Loading...
