2.7.3 Internal connectors
1. Serial ATA connectors (7-pin SATA 1-6 [blue])
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives and optical disc drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5,
®
Matrix Storage Technology through the
onboard Intel
®
P55 chipset.
•
These connectors are set to Standard IDE mode by default. In Standard
IDE mode, you can connect Serial ATA boot/data hard disk drives to these
connectors. If you intend to create a Serial ATA RAID set using these
connectors, set the item in the BIOS to [RAID]. See
section for details. Before creating a RAID
set, refer to section .
•
You must install Windows
®
XP Service Pack 1 or later version before using
Serial ATA hard disk drives. The Serial ATA RAID feature is available only if
you are using Windows
®
XP SP1 or later version.
•
When using hot-plug and NCQ, set the in the BIOS to
[AHCI]. See section for details.
To Next Page
Loading...
