EN 11
•
If you want to make a fi xed connection, make sure
that a omnipolar switch with a contact separation
of at least 3 mm is fi tted in the supply cable.
•
The equipment should not be connected to the
network via a multi-plug socket or extension lead,
as the safe use of the equipment can then not be
guaranteed.
•
WARNING: Never open the appliance casing.
The casing may only be opened by a service
technician.
•
Disconnect the appliance from the mains supply
before starting any repair work.
•
Appliance should allow to disconnection of the
appliance from the supply after installation. The
disconnection may be achieved by having the plug
accessible or by incorporating a switch in the fi xed
wiring in accordance with the wiring rules.
If the safety instructions and warnings are not
followed, the manufacturer cannot be held
responsible for any resulting damage.
If you decide to discontinue using the appliance
because of a fault, we recommend you cut o the
cable after removing the plug from the plug socket.
Take the appliance to your municipality’s waste
disposal site.
SAFETY (CONTINUED)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
