installation
building in
1. Check if the kitchen cabinet and the cut out are in
accordance with the instructions (see 'safety' and
'building in dimensions').
2. Remove the protective foil of the sealing strip (A)
and attach the sealing strip in the groove of the
aluminium profiles.
3. If the woodtop is made of treated wood, then
coat the sawn surfaces of the top with sealing
varnish, to prevent moisture causing the top to
swell.
4. Turn the appliance over and put it in the cutout.
5. Connect the appliance to the electricity supply.
6. Check its operation. If the appliance has been
connected incorrectly, it will emit a beep signal.
7. Hand over the instructions to your customer.
NB: Immediately after switching on the fan will start.
The appliance will now carry out a self-check for
a few seconds.
GB 35
A
700001624100 HL HI6071M.qxp 12-10-2005 12:09 Pagina GB 35
To Next Page
Loading...
Need help?
General
