Atag iR 15 - Commissioning

Installation & Servicing instructions ATAG iR-Range
39
15 Commissioning
Work on the installation and/or boiler should only be carried out by qualied personnel with
calibrated equipment.
At the time of commissioning, complete all revelant sections of the Benchmark Checklist located on
the inside back pages of the document.
For maintenance of the boiler the cover has to be removed.
Unscrew the 2 locking screws from the fasteners at the top of the boiler, unlock the fasteners and remove the
cover in a forward motion.
Note that there is an earth cable (when present) to disconnect when removing the boiler front panel.
Free space for removing the connector is about 400 mm. Remember to connect this earth cable
(when present) when placing back the boiler front panel and take care the wire does not get stuck
between front panel and boiler. Always replace and turn the 2 screws tight in the fasteners A and B.
Changingsettings,suchastheburnerpressureandtheamountofairow,issuperuous.Onlyincaseofa
failure or when replacing the gas block, venturi and/or fan, the CO
2
percentage should be checked.
Always check all gas carrying parts for leaks (with a leak detection spray) after (maintenance) work
to the boiler.
Closetherelevantcommissioningvalvesduringthemaintenanceactivities.Seegure15.a.
Draining the boiler
Theheatinginstallationmustbeprovidedwithallanddrainvalve.Usethisfeaturealsofordrainingthe
boiler.
OPEN CLOSED
CH FLOW CH RETURNGAS
Figure 15.a