AT&T 610 - Page 18

· Unpack ancl Install .
User's Guicle
August 1985
Page 1- 4
g. Insert lower tabs into cutouts and pivot
controller/base upward so that latches on swivel
engage upper cutouts on monitor. This secures the
controller/base to the monitor. The controller/base
can be unfastened from the monitor by pinching the
release levers of the latches and pivoting the
controller/base away from the monitor.
Latch-
Pinch to
Unlatch
Upper Cutouts
Insert Here First -
Then Pivot Up Until
Latches~ Engage
Monitor
r-------------
, \
I \
I \
, \
,
I \
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
------------------~
Lower
Cutouts
Styrofoam
Pack
l':ig1Ire 1-4. A&aeJlhly of Controller/Base to 1I0nitor
h. Tip monitor and controller/base to upright position
and remove styrofoam pack and plastic bag.
1. Connec t monitor cable to connector marked "VIDEO" on
controller/base. Secure cable to controller/base with
two captive screws on connector.
3. Remove the tissue wrapped package from the bottom of the
monitor carton. The. ac power cord is wrapped in this
paper. Unwrap the cord.
4. Connect the female end of the power cord to the ac
connector on the back panel of the monitor.