AT&T 610 - Page 19

User's Guide
AIIgust 1985
Figure 1-5. AC Connection
Male
Unpack and Install
P.e 1- 5
5. Check that ac power switch (on front) is off. Insert male
end
of cord into a 110 Vac outlet (or other power source).
6. Open end of keyboard carton and remove styrofoam pack.
7. Remove tape securing both halves of styrofoam pack,
separate the pack, and remove the keyboard.
Rote: Plastic bag deleted for clarity.
Carton
I'fgure 1-6. .yboard Paeldag
8. Identify the keyboard (check Figure 1-9).
9. Place the keyboard near the display.
10. Insert the keyboard connector into the receptacle in the
rear of the controller/base.