AT&T 610 - Page 56

TendDal Setup
Page 5- 4
Option
Send Parity
Check Parity
Local Echo
Monitor Mode
Selections
even*
odd
mark
spac
none
yes
no*
off*
on
on
off*
Description
This option determines what state
the 8th bit of sent data will be.
If even or odd is selected, the
8th bit will. be sent to reflect
the selected parity. If mark (1)
or spac (space) (0) is selected,
the 8th bit will be sent as
selected. If none is selected,
the 8th bit will be sent as space.
User's Guide
August 1985
This option determines whether
received data is compared to the
Send Parity option. If "yes,"
errored characters are replaced by
SUB characters (SB); if "no,"
received data parity is ignored.
When the terminal is in Monitor
mode, received parity will not be
checked.
If "off," keyboarded data is sent
to the line only and must be
echoed back by the remote receiver
to be seen on the terminal. If
"on," keyboarded data will be sent
to the line and the display at the
same time.
If "on," received escape sequences
and control characters will be
displayed but not acted upon. LF,
VT, and FF will be displayed and
then acted on as newline (CR/LF).
If "on," the terminal will do an
autowrap when the cursor is in the
last column and data is received.
The control characters SI and SO
will not be operational to move in
and out of GO. When this option
is "off," control characters are
not viewed.