AT&T 610 - Page 66

Operat:lous
Page 6- 4
0------ ;
'I NONSCIIO&.LlNG I
I STATIC· REGION I
r-------------1
I! 8C11OLLING RIGION ! I
L __ ~ ___________ ...J
0- - ,--------------;
I ! 1· I
I SCROLLING IIIGIOM • I
r-- -----------1 .
I NOIIIICROLLING I
I . STATIC RIGION I
L ______________ ...J
ODD DO I n ICJ
DOD LJD InC]
Exaaple: One Static and One Scrolling Region
O-----S:~REGION -;
~----------------------~
:! SCROLLING REGION t l
~--------------------~
I STATIC REGION I
L __________ ,-.J
DOD DO Dr=rJ
Exaaple: Tw 0 Static Regions and One Scrolling Region
Note 1: On power up, the scrolling region is set to line 1 and
line 24 (a single twenty-four line scrolling region).
Note 2: Line insert and line delete (refer to Section 8)
operate only in the scrolling region.
User .... s Guide
August 1985
Note 3: When autowrap (refer to Section 5) is enabled and the
cursor is in the last line of the display in a
nonscrolling region, a newline will position the cursor
at the beginning of the same line.
Host-¥riteable Status Line
A host can write to the status line (line 25) by using
cursor positioning (refer to Section 8) to the status line.
Autowrap is off while the cursor is in this line. The United
States character set (refer to Section 8) is always used on the
status line. The following control characters and sequences are
not allowed on the status line: linefeed, vertical tab,
formfeed, index, reverse index, newline, cursor save, cursor up
or down, and clear screen to/from cursor.