9
5 Connect the power cord to the phone.
Fit the power cord behind the strain relief tab. Then plug the
smaller end of the power cord into the jack labeled POWER at
the back of the system.
6 Connect the line cord(s) to your modular jack(s) and
mount the phone onto the wall.
• If you have a two-line jack, plug the free end of the line cord
into the modular wall jack. Make sure the cord snaps firmly
into place. Place the phone on the wall jack mounting studs
and pull down until it is held securely.
• If you have two separate jacks, plug the free end of the cord
with blue plugs into the modular wall jack for Line 1. Plug the
free end of the cord with clear plugs into the modular wall
jack for Line 2. Make sure the cords snap firmly into place.
Place the phone on the mounting studs of one wall jack and
pull down until it is held firmly in place.
7 Connect the handset to the telephone.
Plug the coiled cord into the handset jack on the side of the
phone. Plug the other end of the coiled cord into the handset,
and then hang up.
8 Plug the power cord into an AC outlet not controlled by
a wall switch.
9 Follow Steps 6 through 12 in “Table/Desk Installation.”
INSTALLATION
To Next Page
Loading...
Need help?
General
