Answering system
71
Answering system settings
Remote access code
To access your answering system remotely from any touch-tone
phone, you need to enter a two-digit number (00-99). By default,
the remote access code is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/SELECT to enter
the main menu.
2. Press qCID or pDIR to scroll to Answering sys, then press
MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then press
MENU/SELECT.
4. Press qCID or pDIR to scroll to Remote code, then press
MENU/SELECT.
5. Use the dialing keys to enter a two-digit number. Press
MUTE/DELETE to backspace and delete a digit.
6. Press MENU/SELECT to save the setting.
Message alert tone
When the message alert tone is set to On, and there is at least one
new message, the telephone base beeps every ten seconds. By
default, the message alert tone is set to o.
There is no audible alert at the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/SELECT to enter the
main menu.
2. Press qCID or pDIR to scroll to Answering sys, then press
MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then press
MENU/SELECT.
4. Press qCID or pDIR to scroll to Msg alert tone, then press
MENU/SELECT.
5. Press qCID or pDIR to choose On or Off.
6. Press MENU/SELECT to save the setting.
To Next Page
Loading...
Need help?
General
