Answering system
74
Answering system settings
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a 2-digit number (00-99). By default, the remote access code is
19.
To change the remote access code:
Using a cordless handset:
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to >Ans sys setup, then
press MENU/SELECT.
4. Press qCID or pDIR to scroll to >Remote code, then press
MENU/SELECT.
5. Use the dialing keys to enter a 2-digit number. Press
MUTE/DELETE to backspace and delete a digit.
6. Press MENU/SELECT to save the setting. You hear a
confirmation tone.
Using the telephone base:
1. When the telephone base is in idle mode, press
MENU/SELECT to enter the main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to >Ans sys setup, then
press MENU/SELECT.
4. Press qCID or pDIR to scroll to >Remote code, then
press MENU/SELECT.
5. Use the dialing keys to enter a 2-digit number. Press
X/DELETE to backspace and delete a digit.
6. Press MENU/SELECT to save the setting. You hear a
confirmation tone.
Play messages
>Answering sys
p
q
Answer ON/OFF
>Ans sys setup
p
q
REMOTE CODE
19
Play messages
>Answering sys
p
q
Answer ON/OFF
>Ans sys setup
p
q
REMOTE CODE
19
To Next Page
Loading...
