58
Your telephone can support up to 12 DECT 6.0 cordless handsets (AT&T model
CRL30102, sold separately) or up to 10 cordless handsets and 2 cordless
headsets (sold separately). Visit www.telephones.att.com/headsets
for a list of compatible DECT 6.0 cordless headsets. Each new handset or
headset must be registered to the telephone base before use. You must
register each handset or headset separately.
To register a cordless headset to this telephone system, please refer to the
user’s manual of the cordless headset for more details. To register a cordless
handset, see below.
The handsets provided within your product box are already registered as
HANDSET 1, and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HANDSET 12).
Register a handset to your telephone base
1. Before you begin registration, make sure the handset is
out of the telephone base or charger and shows To
register HS, see manual.
2.
Put the handset you wish to register on the telephone
base cradle.
3. The screen shows Registering... Please wait and the
IN USE light turns on. It takes up to 90 seconds to
complete registration. Then, HANDSET X Registered
appears on the screen, with X being the handset
number (1-12). The handset beeps and the IN USE
light turns off. The handset is now registered with the
telephone base.
If registration fails, the system will automatically try
to register again. If registration fails after the third try,
Registration failed appears on the screen for a few
seconds, and then To register HS, see manual. This may
take up to five minutes to occur. Please start
again from Step 1.
Appendix
Adding and registering handsets/headsets
HANDSET 2
10/20
10:30
PM
Registering...
Please wait
To register HS,
see manual
For registration, put the handset
on the telephone base, not the
handset charger.
To Next Page
Loading...
