AT&T DLP73390 - Message Alert Tone

152
Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at
least one new message, the telephone base beeps every 10
seconds. The tone stops when all new messages have been
reviewed. By default, the message alert tone is O.
To turn on or o the message alert tone:
Using a cordless handset:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press
MENU/SELECT .
3. Press CID or DIR to highlight Ans sys setup, then press
MENU/SELECT .4. Press CID or DIR to highlight Msg alert tone, then
press MENU/SELECT .
5. Press CID or DIR to choose On or O, then press
MENU/SELECT .
Using the telephone base:
1. Press Menu sokey, and choose Answering system .
2. Press / / / to scroll to the next page, and then select
Message alert tone .
3. Press Turn ON to turn on. Message alert tone ON displays.
Notes:
f Press any base keys except FIND HS to temporarily disables the message alert tone until a new message is received.
f The message alert tone beeps only if all the following conditions are met.
– Answering system is on.
– Message alert tone setting is on.
– There are new messages.
Msg alert tone
ECO
Off
ECO