AT&T DLP73390 - Set Date;Time

54
Telephone settings
Telephone base settings
Set date/time
The answering system announces the day and time of each message prior
to playing it. Before using the answering system, set the date and time as
follows. If you subscribe to caller ID service, the day, month and time are set
automatically with each incoming call. The year must be set so that the day
of the week can be calculated from the caller ID information. You can turn o
the date and time settings of the caller ID service and set the date and time
manually (see Use caller ID to automatically set date and time on page 59).
Aer a power failure, the system prompts you to set the date and time.
To set the date and time manually:
1. Press MENU on the telephone base in idle mode to enter the main menu.
2. Press or to scroll to the next page, and then press the
Set date / time smart key to enter.
3. Use the dialing keys (0-9) to enter the month (--), date (--) and year (--).
Then, press Next .
4. Use the dialing keys (0-9) to enter the hour (HH) and minute (MM). Then,
press or to choose AM or PM.
MENU 2/2
Bluetooth
Set date / time
Smart key
Ringers
Settings
Access
voicemail
Previous
MONTH DATE YEAR
-- / -- / --
SET DATE
Next
Back
5. Press Save to save.
Note: If the clock is not set when a message is recorded, the system announces, “Time and day not set,” before it
plays the message.