AT&T GL2101-2 User Manual

10
Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use.
Telephone base installation
Plug one end of the
telephone line cord into a
telephone jack or a DSL lter.
Plug the small end of the
telephone base power adapter
into the power adapter jack on
the back of the telephone base.
Plug the large end of the
telephone base power adapter
into a power outlet not
controlled by a wall switch.
Plug the other end of the telephone
line cord into the telephone jack on
the back of the telephone base.
If you have DSL high-
speed Internet service, a
DSL lter (not included)
is required.
Route the
telephone line cord
through this slot.
Route the power
adapter cord through
this slot.

AT&T GL2101-2 Specifications

General

Brand	AT&T
Model	GL2101-2
Category	IP Phone
Language	English