Troubleshootlng Chart (continued)
Trouble
Possible Cause
Do This
The voice terminals do not ring.
● The volume control is turned off. ● Turn up the volume.
●
The lines are programmed not to ring.
●
Program line ringing as desired.
● The Do Not Disturb feature is
●
Touch
Do Not Disturb
to deactivate the
activated.
feature. (The green light goes off.)
●
If the buttons on your voice terminal are
not labeled, check each programmable
button to see if the green light next to it is
on; the Do Not Disturb feature should be
on one of those buttons. Then, reprogram
those buttons.
The voice terminal will not stop
● The T/P switch may be set to P
●
Slide the T/P switch to the center position.
ringing.
(Program).
One custom feature does not work,
● The feature was not programmed
● Reprogram the feature to the same
but the others do. correctly.
button.
●
The feature is not being used correctly.
●
Review the description of the feature’s use
in the User’s Guide: Models 206 and 410
with Feature Package 1.
19
To Next Page
Loading...
