74
75
• CHARGERS
Main powered chargers will operate within the temperature
range of 0°C(32°F) to 45°C(113°F).
The chargers designed for your device meet with the standard
for safety of information technology equipment and office
equipment use. They are also compliant to the eco design
directive 2009/125/EC. Due to different applicable electrical
specifications, a charger you purchased in one jurisdiction may
not work in another jurisdiction. They should be used for this
purpose only.
• Electronic Recycling
For more information on Electronic Recycling:
1) Visit TCL Electronic Recycling Program website at https://
www.tcl.com/us/en/mobile/accessibility-compliance/tcl-
mobile-electronic-recycling-program.html, or
2) Call TCL USA Customer Support at 1-855-224-4228.
• Battery Recycling (USA & Canada):
TCL partners with Call2Recycle® to offer a safe and convenient
battery recycling program. For more information on our
Battery Recycling Program, please visit the USA and Canada
website at https://www.tcl.com/us/en/mobile/accessibility-
compliance/tcl-mobile-battery-recycling-program.html
• Federal Communications Commission (FCC) Declaration
of Conformity
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user‘s authority to
operate the equipment.
This device has been tested and found to comply with the
limits for a Class B digital pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation if this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio technician for
help.
FCC Caution:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user‘s authority to
operate the equipment.
FCC RF Exposure Information (SAR):
This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy
set by the Federal Communications Commission of the
United States.
During SAR testing, this is set to transmit at its highest
certified power level in all tested frequency bands, and
To Next Page
Loading...
Need help?
General
