AT&T TL88102 - Message Alert Tone; Enabling;Disabling Message Alerts

65
Answering system
Answering system settings
Number of rings
You can set the answering system to answer an incoming call after two,
four or six rings; or toll saver. With toll saver selected, the answering system
answers after two rings when you have new messages, and after four
rings when you have no new messages. This enables you to check for new
messages and avoid paying unnecessary long distance charges if you are
calling from out of your local area.
Using the telephone base:
1. Press the MENU soft key when the telephone base is not in use.
2. Press the SELECT soft key to select to select Answering sys.
3. Press qCID or pDIR to choose Mailbox 1 or Mailbox 2, then press the
SELECT soft key. The corresponding icon,
1
or
2, flashes on the
screen.
4. Press qCID or pDIR to scroll to Ans sys setup, then
press the SELECT soft key.
5. Press qCID or pDIR to scroll to # of rings, then press
the SELECT soft key.
6. Press qCID or pDIR to choose 2, 4, 6, or Toll saver,
then press the SET soft key to confirm your setting.
There is a confirmation tone. Or press CANCEL to exit
to the previous menu without making any changes.
Using the handset:
1. Press the MENU soft key when the handset is not in use.
2. Press the SELECT soft key to select ANSWERING SYS.
3. Press qCID or pDIR to choose Mailbox 1 or Mailbox 2, then press the
SELECT soft key. The corresponding icon,
1
or
2
, flashes on the
screen.
4. Press qCID or pDIR to scroll to Ans sys setup, then press
the SELECT soft key.
5. Press qCID or pDIR to scroll to # of rings, then press the
SELECT soft key.
6. Press qCID or pDIR to choose 2, 4, 6, or Toll saver, then
press the SET soft key to confirm your setting. There is a
confirmation tone. Or press the BACK soft key to exit to
the previous menu without making any changes.
1
Announcement
# of rings
Remote code
SELECT
1
# OF RINGS
2
4
SELECT
1
BACK
SELECT
ANS SYS SETUP
Announcement
# of rings
Remote code
1
BACK
SET
# OF RINGS
2
4
6