AT&T TL88102 - Delete All Messages; Deleting All Old Messages

67
Answering system
Answering system settings
Message alert tone
When the answering system is turned on, the telephone base beeps every
10 seconds to alert you of new messages. The alert stops when all new
messages have been reviewed.
Using the telephone base:
1. Press the MENU soft key when the telephone base is not in use.
2. Press the SELECT soft key to select to select Answering sys.
3. Press qCID or pDIR to choose Mailbox 1 or Mailbox 2, then press the
SELECT soft key. The corresponding icon,. The corresponding icon,
1
or
2, flashes on the
screen.
4. Press qCID or pDIR to scroll to Ans sys setup, then
press the SELECT soft key..
5. Press qCID or pDIR to scroll to Msg alert tone, then
press the SELECT soft key..
6. Press qCID or pDIR to choose On or Off, then press
the SET soft key to confirm your setting. There is a
confirmation tone. Or press CANCEL to exit to the
previous menu without making any changes.
Using the handset:
1. Press the MENU soft key when the handset is not in use.
2. Press the SELECT soft key to select ANSWERING SYS.
3. Press qCID or pDIR to choose Mailbox 1 or Mailbox 2, then press the
SELECT soft key. The corresponding icon,
1
or
2
, flashes on the
screen.
4. Press qCID or pDIR to scroll to Ans sys setup, then press
the SELECT soft key.
5. Press qCID or pDIR to scroll to Msg alert tone, then
press the SELECT soft key.
6. Press qCID or pDIR to choose On or Off, then press
the SET soft key to confirm your setting. There is a
confirmation tone. Or press the BACK soft key to exit to
the previous menu without making any changes.
1
# of rings
Remote code
Msg alert tone
SELECT
1
MSG ALERT TONE
On
Off
SET
1
BACK
SELECT
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
1
BACK
SET
MSG ALERT TONE
On
Off