16
Configuring a User Controllable Dial as Primary Configuration
To configure a Cellular User Controllable Dial as Primary connection, follow these steps after reaching Figure 4:
1. Ensure your supported Cellular USB modem is inserted into one of the two USB ports on the back of the U115 or
if an internal modem is installed that a SIM has been inserted.
2. Select the radio button next to “Cellular” in the “User Controllable Dial as Primary Connection” section and click
OK to proceed to the setup sequence.
3. Select your modem type from the drop down menu on Figure 10. For more detailed information on supported
Cellular modems and associated configuration, please contact your IS Department.
4. The Access Point Name and AT Strings are optional fields that you can enter information into if they are required.
If these fields are not required, then leave them blank. Click NEXT to proceed to the next page.
5. Enter the phone number provided by your Cellular service provider on Figure 11.
6. Enter the user ID and password provided by your Cellular service provider. Some networks/APNs don't use the
user ID and some Cellular service providers require that the user ID is NOT sent. In those cases, enter “empty”
(without quotes) for both the user ID and password to ensure that no user ID and password information is sent in
the authentication flow.
7. Select your Dial Internet connection method from the drop-down menu.
8. At the end of the setup, you will see a summary of the configuration and will be asked to reboot to pick up the
new configuration. After reboot, skip to the section titled “Establishing VPN Connectivity” on page 20.
To Next Page
Loading...
