Operating instructions AQUAMAX
®
BASIC/CLASSIC
ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com /
Art.-No.: 9060 0270 / Status: 09.06.2023 /
Page 10 from 36
Commissioning
With first commissioning basic settings and tests are carried out. Please ensure that all information
for this is available. With input of the plant values all important parameters are pre-set. However,
we recommend that, following commissioning, the parameters are again checked under
Settings, as false values can, inter alia, lead to an increased power consumption.
In the Service Mode you have the possibility later of undertaking modifications.
Language selection
Enter language you need. German, English, French, Italian, Romanian,
Polish, Slovenian, Spanish, Dutch are available.
Password input
Please enter the six-figure code number.
Date and time
Enter the date and time.
Important for the correct entries in the logbook
Selection of the plant type
Select between BASIC or CLASSIC.
Number of inhabitants
Select the connected PT.
The settings belonging to the number of inhabitants are carried out
automatically.
Serial number
Here you enter the serial number that is located on the sewage treatment
plant. Please make sure to enter the serial number right-justified so that there
are leading zeros.
The SSID of the control unit is also defined with the entry (for mobile access
via WiFi Direct). The SSID should be assigned "systematically". If not the
system serial number (preferably), then e.g. the serial number of the control unit. A subsequent
change is possible in the settings.
=WiFi-No.-endin
To Next Page
Loading...
