Operating instructions AQUAMAX
®
BASIC/CLASSIC
ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com /
Art.-No.: 9060 0270 / Status: 09.06.2023 /
Page 9 from 36
Control unit ATBcontrol
©
3 - Connect
Features
Features
Microprocessor controlled
USB connection for data readout and input
Splash water protected. Conditionally suitable for outside areas (IP54)
Wall mounting
Voltage failure detection system (UVS
®
)
Floating contact for an additional alarm facility
Simple and rapid operation
Times for all parameters completely pre-programmed
Automatic run-in phase with suppression of excess sludge removal
Parameter settings freely selectable
Alarm interval
Alarm volume adjustable
Deployable for AQUAMAX
®
BASIC / CLASSIC
Plug-in
Winter operation and sludge removal mode for the reduction of the aeration times
Mobile access via internet browser (e.g. with smartphone or tablet) via WiFi-Direct
General information on operation
The operation of the control unit takes place via three short-stroke keys. By pressing a key the
display illumination is switched on (lapses if no key is operated within 5 minutes).
Key functions:
↑↓ Scroll upwards or downwards / menu selection
OK Transition of cursor to the character, which is to be changed / value input is saved /
selection of menu point / menu setback.
With temperatures below 0°C a severely limited function of the LC display is to be anticipated.
To Next Page
Loading...