Operating instructions AQUAMAX
®
BASIC/CLASSIC
ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com /
Art.-No.: 9060 0270 / Status: 09.06.2023 /
Page 15 from 36
Service mode
The access to the Service Mode takes place via a 6-figure code number,
which is made available exclusively to the authorised specialist firm.
In the Service Mode all parameters relevant and necessary for the
operation of the wastewater treatment plant are set and changed. Please
note that false inputs can lead to a faulty process!
The inputs are not checked for plausibility! ATB WATER
GmbH rejects any claims under warranty for the results of
inappropriate inputs!
Our service department will be very happy to provide you
with support.
Operating parameters
With the selection of the PT number with
commissioning, the parameters lodged in the
memory are loaded. At this point you have the
chance of carrying out modifications. For
description of the individual points see above
(Settings).
Product type
Selection of the product type.
Inhabitants
Selection of the connected inhabitants. The
associated parameter values are loaded
automatically.
Current Limits
Minimum/maximum current consumption of the
individual units below/above which an alarm
signal takes place.
Serial number
Here you enter the serial number that is located
on the sewage treatment plant. Please make sure
to enter the serial number right-justified so that
there are leading zeros.
The SSID of the control unit is also defined with the entry (for mobile access via WiFi
Direct). The SSID should be assigned "systematically". If not the system serial number
(preferably), then e.g. the serial number of the control unit. A subsequent change is
possible in the settings.
=WiFi-No.-endin
To Next Page
Loading...
