Operating instructions AQUAMAX
®
BASIC/CLASSIC
ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com /
Art.-No.: 9060 0270 / Status: 09.06.2023 /
Page 5 from 36
taken. The applicable accident prevention regulations and rules of technology are to be complied
with.
In the versions with submersible aerator the AQUAMAX
®
feeds the required air to the wastewater
through a rapidly rotating propeller. Never work in the vicinity of the aerator as long as the
AQUAMAX
®
is connected with the mains. Danger of injury!
The correct function can only be guaranteed with the employment of original spare parts or spare
parts approved by ATB. Before commissioning, all points of the operating instructions are to be
checked. Keep these instructions readily to hand at all times!
Explanation of the warning notices used:
Attention! Danger due to electrical voltage!
Rotating parts. Danger of crushing and being drawn into the area of the submersible aerator!
The ATBcontrol
©
3 Connect is delivered as a ready-to-plug-in version. There is no need for wiring
on site.
ATTENTION! Before opening the ATBcontrol
©
3 – Connect and/or the connection
box it/they must be disconnected from the mains supply. Work on opened units
may be carried out exclusively by qualified electricians! Pay attention to phase-
correct connection (even with plug-in design)!
As you are concerned with an electrical plant with submerged motor units, a
separate B16 fuse and a (separate) upstream 30 mA ELCB (earth leakage circuit
breaker) is absolutely essential!
Attention is to be paid to correct laying of the protective earth conductor up to the
earthing of the building.
Make sure that no damage to persons, material or downstream equipment can
occur, especially during the manual commissioning of units (manual operation)!
To Next Page
Loading...
