ATCOM A10 - Page 29

A10/A11/A10W/A11W IP Phone User Manual
ATCOM TECHNOLOGY CO., LIMITED www.atcom.cn
29
1. Display Name: This name will be displayed on the LCD. It will show the User ID instead if leave
Display Name as blank.
2. User ID: Username of sip account.
3. Authenticate ID: Normally is the same as User ID, but blank is acceptable.
4. Password: Password of SIP account.
5. SIP Server: SIP server address, support both IP address and domain name.
6. SIP Port: SIP server port, defaults to 5060.
7. SIP Redundancy Server: SIP redundancy server address.
8. Use Outbound Proxy: Select “Yes” or “No” to enable or disable outbound proxy.
9. Outbound Proxy Server：Set address of Outbound proxy server. All signaling requests will be
sent to outbound proxy server firstly.
10. Outbound Proxy Port: Outbound proxy server port.
11. Local SIP Port: Set the local SIP port.
12. Register Expires: Register expiration time, defaults to 300 seconds.
13. Subscribe Expires: Subscriber expiration time, defaults to 3600 seconds.
14. Transport Type: UDP/TCP/TLS. Defaults to UDP.
15. SIP 100Rel Require: Select “Yes” or “No” to enable or disable 100Rel. If enabled, 100rel
parameters will be added to the SIP request to support PRACK.
16. Rport Enable: Select “Yes” or “No” to enable or disable Rport.
17. Session Timer Enable：Select “Yes” or “No” to enable or disable Session Timer.
18. Early Update Enable：Select “Yes” or “No” to enable or disable Early Update.
19. Caller ID Display: Select “Yes” or “No” to enable or disable Caller ID display
20. AutoSubscribeMWIEnable：Select “Yes” or “No” to enable or disable SubscribeMWI
21. Server List：Choose the server type.
22. DNS Mode: Choose the DNS mode
23. BLF List URI: Set BLF list URI when A10/A11/A10W/A11W cooperates with Broadworks
(Broadsoft).
24. NAT Mapping Enable: Select “Yes” or “No” to enable or disable NAT Mapping.
 Codec Configuration