Once you are connected with your web browser on the TERRACOM device, the device
will show you all the TERRACOM devices on the network. You just need to press on “Add”
and give a name to the device. If you want to add an “offline” device or a “third party” device,
you need to know its IP address.
You might need also to add the device itself, if you want to play messages or to have
actions locally. In this case, you should give it the IP address: 127.0.0.1:5600.
Function Libraries
On the PPM-IT5, you can create different kind of events.
Device Group
This function is used to create a group of device. It will be used by the scheduler to trigger
prerecorded messages into this group.
Command (String)
This function is used to control a 3
rd
party device with a PPM-IT5.
Logic out (Old)
This command is used to trigger one logic out of another device and change the status of
logic out(hight<->low).
Macro
A macro is another page on the touchscreen to manage key buttons.
Paging group
This function is used to create a group of devices that you can use to page in once. On
the touchscreen you will have one button representing the group.
Locked button
With this function, you set logic out to high and to low. The difference with “Logic out”
function is that if you set the logic out to high, you have then to change the logic out to low, if
you want the logic out to go back to low.
Third party Controls
This function is to declare a list of commands that a 3
rd
party device could trigger. This
function allows a third party device to control the PPM-IT5.
External Variable
This really interesting function is used if you want to show on the PPM-IT5 touchscreen
the status of a non-Terracom device.
How to use the function libraries
To Next Page
Loading...