Ateis PPM-IT5 - Advanced Network Features; SIP Server and NAT Traversal Settings; Address Book Device Management; Touch Panel GUI Button Linking

If you create a direct link without SIP and the target device is in the same LAN than your device:
Even if you are not using a SIP server, the TERRACOM devices will use a SIP
connection (transparent for you). Then select Terranet for the Firewall Traversal
Mode and set up the same SIP port value for each TERRACOM device. Configure
also the RTP port. You can leave the WAN IP blank.
If you create a direct link without SIP and the target device is NOT in the same LAN than your
device,
you might need a NAT Traversal. Then select the Terra net:
Enter the (SIP & RTP) ports you will use.
the WAN IP address is detected automatically, then you can leave it blank.
Address book
Add now in the address book of the TERRACOM device, the list of devices you want
to be able to call.
Setup ->Device List ->Add New Device…
In the URI, write name_device@XXX.XXX.XXX.XXX:YYYY
• For a call with a SIP server: XXX.XXX.XXX.XXX = the SIP server IP address
• For a direct call: XXX.XXX.XXX.XXX= the IP address of the device you want
to call.
• For a local output: XXX.XXX.XXX.XXX=127.0.0.1
YYYY= the SIP port number you have entered in the SIP settings.
Touch panel GUI
On the touchscreen you want to have the list of the devices you want to call.
You can link to a button:
• a Terracom device
• a group of Terracom devices
• a command