Why are there ghost images on my ATEN CL5708's external monitor?
If you observe ghost images on your external monitor when using the ATEN Switch, this may be due to an excessive distance between the external console and the CL5708 / CL5716. To resolve this, replace the existing VGA cable with a shorter one that is appropriate for the distance required.
General| Device Type | KVM Switch |
|---|---|
| Number of Ports | 8 |
| USB Ports | 2 |
| Audio Support | Yes |
| Computer Connections | 8 |
| Console Connections | 1 |
| Daisy Chain | No |
| Maximum Computers | 8 |
Detailed list of the CL5708/CL5716's key capabilities and functionalities.
Specifies the hardware and software needed for system setup.
Lists hardware components required for an external console connection.
Details the equipment that must be installed on each connected computer.
Describes recommended cable types for optimal signal integrity and layout.
Lists the supported operating systems for connected computers.
Identifies and describes the physical parts of the KVMP switch.
Instructions on how to slide out and open the integrated LCD console.
Steps to properly slide the console module back into the unit.
Safety guidelines for using the keyboard module to prevent damage.
Procedure for safely powering down and restarting the KVMP switch.
Features for controlling computer access directly from the keyboard using hotkeys.
General safety precautions for operating and handling the device.
Information on how to obtain technical assistance and support.
Technical details and parameters of the CL5708/CL5716 models.
Instructions for mounting the switch using the provided standard rack mounting kit.
General advice for solving operation problems, including cable checks and firmware updates.
To Next Page
