FG_D6_CCLINK_EN_02 / 2020-06-17
“INSTRUCT. “
DP Instruction
“NEXT PROG.”
Number of the following program in sequencing.
“INIT PRESS” *
Initial pressure
“STEP PRESS” *
Step pressure
“END PRESS” *
Final pressure
“STP MIN P” *
Step minimum pressure
“STP MAX P” *
Step maximum pressure
“S.MIN FLOW” *
Step minimum flow
“S.MAX FLOW” *
Step maximum flow
“CONTACT” (Up contact menu) *
Up contact type
“CONTACT” (Down contact menu) *
Down contact type
“UP.MIN FL” *
Up minimum flow parameter
“DN.MAX FL” *
Down maximum flow parameter
“UP P.MIN” *
Up minimum pressure
“UP P.MAX” *
Up maximum pressure
“DN P.MIN” *
Down minimum pressure
“DN P.MAX” *
Down maximum pressure
“START PRESS” *
Instruction the pressure begin to be measured
“ATR DRIFT”
Drift transient (ATR).
“DELAY EXT1”
Programmed external output 1 delay time.
“DELAY EXT2”
Programmed external output 2 delay time.
“DELAY EXT3”
Programmed external output 3 delay time.
“DELAY EXT4”
Programmed external output 4 delay time.
“DELAY EXT5”
Programmed external output 5 delay time.
To Next Page
Loading...
