ATEQ D620 - Page 19

D620.388.00_QS_UK_01
19 / 42
Pin number Inputs / outputs Description
1 Input 1 RESET
2 + 24 V DC Common
3 Input 2 START
4 + 24 V DC Common
5 Input 3 Program selection
6 Input 4 Program selection
7 Input 5 Program selection
8 Input 6 Program selection
9 Input 7 Program selection (programmable input)
10 Output Common floating output
11 Output Pass part
12 Output High flow fail part
13 Output Low flow fail part
14 Output Warning
15 Output End of cycle
16 0 V Ground
The device can be energized through a theJ11 connector of the relay board (except if internal
supply option):
– 0 V to the pin16
– 24 V DC to the pin2 or4.
Program selection extension connector (J10) (option)
The J10 connector is an extension of the J11 connector that enables the selection of128
programs.
Characteristics
— Inputs
• Activation: + 24 V DC.
Pin number Inputs/outputs Description
I8 Input 8 Program selection from 33 to 64 (programmable
input)
I9 Input 9 Program selection from 65 to 128 (programmable
input)