ATEQ D620 - Selecting a Program; Starting and Stopping Current Cycle

D620.388.00_QS_UK_01
36 / 42
SELECTING A PROGRAM
If necessary, you can select another program.
1. Press up/down .
Pr 002
INDIRECT FLOW
STARTING AND STOPPING CURRENT CYCLE
Use the front panel keys to start/stop a measurement cycle.
With the desired program displayed on the Program screen:
STARTING A MEASUREMENT CYCLE
1. Press Start .
The cycle phases of the program are successively displayed:
WAITING
FILL
STABIL.
TEST
DUMP
At the end of the cycle, the results are displayed and
READY appears at the bottom right of the screen.
During the measurement cycle, you may press to access
the MAIN MENU screen and set parameters for a next
measurement cycle.
600.0
mbar
60.00
30.00
Pr 2
READY
OK
35.15
l/h
STOPPING A CYCLE
2. Press Reset to immediately stop the current
measurement cycle and return to the Program
screen.