ATEQ D620 - Configuration of the ATEQ Device (Slave); Setup of the Station Number

9 / 68
FG_D6_PROFIBUS_EN_01 / 2020-06-17
Configuration of the ATEQ device
(slave)
Use this procedure to configure your device.
This configuration can be done with the front panel of your ATEQ device or with the ATEQ Fieldbus
Configurator software.
SETUP OF THE STATION NUMBER
The station number must be the same on slave and master.
From the ATEQ device
From the MAIN MENU screen of your ATEQ
device:
➢ CONFIGURATION
➢ AUTOMATISM
➢ FIELDBUS
➢ ADDRESS
From the ATEQ Fieldbus Configurator software