—
Read the parameters at the address 20(h):
Word 1 = identifier number of the first read
parameter.
Word 2 and Word 3 = first parameter value
x1000 (long format).
Word 4 = second identifier number of the read
parameter.
Word 5 and Word 6 = second parameter value
x1000 (long format).
Example:
On network:
@20h = 0003h 03E8h 0000h 0002h 01F4h 0000h.
-
0003h: test time identifier.
- 000003E8h: test time value 1000(d)/1000 → 1 sec.
-
0002h: fill time identifier.
-
000001F4h: stabilization time value
500(d)/1000 → 0,5 sec.
The master instrument must always set to zero the command bit. If it is not done, the slave instrument
will not detect the following command on this bit. It has detection on the rising edge (when the bit
state goes from 0 to 1).
To Next Page
Loading...
