• If reading the SGTIN96 code fails, move the tool further away from the tire and restart
the procedure.
• In the case of repeated failures, put the vehicle on a lift to easily access the tire's inner
side or remove the wheel.
• NOTE: The RFID tag is situated on the same side wall as the DOT number, and tire
specification. On directional tires, the RFID will in this case be located on the tire's inner
sidewall. In this case, direct the tool's RFID antenna towards the wheel arch to reach
the inside of the tire.
• Remain on the same Front Left tire, and place the TPMS
tool antenna near the valve stem.
•
• Press the TPMS activation button once, and wait until a beep confirms the successful
programming of the RFID Tire Data into the sensor..
• An animation shows that the data of the TPMS sensor is being read and programmed.
To Next Page
Loading...
