EasyManua.ls Logo

ATESS HPS50 - Safety Instructions; General Safety Warnings; Installation Safety

ATESS HPS50
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
WARNING
Caution,risk of electric shock
WARNING
Caution, risk of fire hazard
PE TERMINAL
Protective conductor terminal
WARNING
Risk of electric shock, Energy storage timed discharge.
3
When battery bank connecting point are exposed, there will be DC voltage in
the equipment DC side; and when output breaker is on, there is a potential
risk of electric shock.
Suitable for mounting on concrete or other non-combustible
surface only.
The inverter has to be firmly grounded to ensure the safety of
personnel.
Electrical shock danger exists in the capacitor; the cover shall
be moved at least 5 minutes later after all powers are
Safety instructions 2
Inverter installation and service personnel must be trained and familiar with the
general safety requirement when working on electrical equipment. Installation and
service personnel should also be familiar with the local laws and regulations and
safety requirements.
> Read this manual carefully before operation. The equipment will not be under
warranty if failing to operate according to this manual.
> Operation on the inverter must be for qualified electrical technician only.
> When inverter operating, dont touch any electrical parts except for the touch-
screen.
> All electrical operation must comply with local electrical operation standards.
> Warranty service for the inverter does not contain module maintenance.
> Permission from the local utility company is required before installing the Energy
Storage system and only professional personnel are qualified for the operation.
2.1. Installation
Proper installation requires following all the instructions in the user manual
involving transportation, mounting, wiring and commissioning. ATESS does not
cover warranty for the inverter damage due to failing to use it properly.
The protection level of the inverter is IP20, which is designed for indoor
installation. Please refer to chapter 4 for installation instruction.
The installation location must be dry, including no expected condensation. The
inverter is only for use in a closed electrical operating area.
Caution, risk of fire hazard
WARNING
Suitable for mounting on concrete or other non-combustible
surface only.

Related product manuals