Atlantic Technology System 6200 - Remote Control and Power Management; Hardwired Remote Control Connections; Amplifier Power and Standby Operation

12
8200/6200 Pedestal Subwoofer System
Figure 13
Remote Control Connections
Connecting Your PedWoofers
Connecting Your PedWoofers
  
 


 
 

   


 
 
  

 
        
  


W
A
R
N
I
N
G
R
I
S
K
O
F
E
L
E
C
T
R
I
C
S
H
O
C
K
D
O
N
O
T
O
P
E
N
A
V
I
S
:
R
I
S
Q
U
E
D
E
C
H
O
C
E
L
E
C
T
R
I
Q
U
E
/
N
E
P
A
S
O
U
V
R
I
R
   
 
 
   
 
    
    
  
  
                    


  
 
 


 


     
     
  
    
   
 



 







Power Connection
Connect the ampli er’s power cord to an AC outlet only after making all
other connections to the PedWoofer system. This will avoid any chance
of accidentally activating the subwoofers while wiring.
DO NOT PLUG
THE AMPLIFIER INTO THE SWITCHED OUTLET OF AN AMPLI-
FIER, PREAMPLIFIER, OR RECEIVER.
The power demands of the SA
ampli ers is substantial and will exceed the power rating of the switched
outlet and may damage the equipment. Be sure that the printed voltage
rating on the back of the ampli er is correct for your location.
The PedWoofer ampli er system is totally automatic in its operation.
Once the main power switch on the front of the ampli er has been
turned on, the automatic on/off circuitry will activate the ampli er in
the presence of an audio signal from your system. After 7-10 minutes
with no signal detected from the rest of the system, the ampli er will
return to the Standby mode. When the ampli er is active, the power LED
located on the front will glow green. The power LED will switch to yellow
in the Standby mode. Power consumption in Standby mode is negligible.
When you leave for long period of time, (vacation, weekend away, etc.)
we recommend shutting off the main power switch on the front panel
of the ampli er.
IMPORTANT NOTE:
The ampli er includes an automatic protec-
tion circuit against overheating, overcurrent or short circuiting of the
speaker wires. Should any of these conditions occur, the ampli er
will stop operating and the ON/STDBY LED will turn red. If this hap-
pens, turn the main power off and check to make sure that there
are no misconnections or shorted connections between the ampli er
and the PedWoofers. After waiting 10-15 minutes for the ampli er
to cool, turn the unit back on. If the ampli er shuts off again, con-
tact your dealer or Atlantic Technology for more information.
The ampli ers generate a fair amount of heat. The louder you play them
the hotter they will become. It is very important to make sure nothing
blocks the ventilation openings on the top and bottom of the unit. Do
not place the ampli er of thick carpeting as the carpet will block the
ventilation holes on the bottom of the unit, restricting air ow through
the interior.