8200/6200 Pedestal Subwoofer System
Write this number in the space provided on page 2 for future ref-
Direct Access Remote Control port
Use for hard-wired direct access of remote control functions.
The IR IN jack accepts an IR signal from a separately pow-
ered system (other than the Atlantic Technology PedWoof-
ers) or an IR signal generated by a “whole-house” controller.
Use the THRU jack to “daisy-chain” other devices to the sensor.
EXT IR Receiver Connector
Use the EXT IR RCVR input powered port to connect to the Ped-
Woofer’s built-in IR receiver when the ampli er is not in line-of-
sight with the remote control. Use the OUT TO SLAVE jack to pass
on the received signal to other equipment.
Use the LO IN jack to connect to the subwoofer or LFE line out
from your processor/receiver. Use the THRU jack to pass the sig-
nal to the other channel of the ampli er or to another device.
High Level Inputs (SA-8200 only)
Use the HI IN binding posts to connect a high level (speaker) out-
put from your processor/ampli er. (page 7)
Use the SPEAKER OUTPUT binding posts to connect the ampli-
er to the PedWoofer. (page 7)
Use the included power cord to connect your ampli er to a wall
Ampli er Back Panel
Items in gray area are found on SA-8200 ampli er only
To Next Page
Loading...
